Specifications

Enterasys RoamAbout Wireless
Management Module Guide
Page 19
Document 5005
- userEtherType(1) - Packets whose Ethernet V2 EtherTypes or IEEE
802.3 LLC/SNAP EtherTypes match the user-defined EtherType
etsysESwitchEtherType[ etsysESwitchProtocolIndex ].
- ipv4(2) - Internet Protocol version 4 carried in Ethernet V2 frames or
IEEE 802.3 frames with LLC/SNAP headers. Also, ARP packets carried
in Ethernet V2 frames.
- ipxEthernet(3) - IPX carried in Ethernet V2 frames.
- ipxRaw(4) - IPX carried in IEEE 802.3 frames with no LLC.
- ipxLlc(5) - IPX carried in IEEE 802.3 frames with LLC headers.
- ipxSnap(6) - IPX carried in IEEE 802.3 frames with LLC/SNAP
headers.
- sna(7) - SNA carried in IEEE 802.3 frames with LLC headers.
- netBios(8) - NetBIOS carried in IEEE 802.3 frames with LLC headers.
- decnet(9) - DECnet carried in Ethernet V2 frames or in IEEE 802.3
frames with LLC/SNAP headers.
- ipv6(10) - Internet Protocol version 6 carried in Ethernet V2 frames
or IEEE 802.3 frames with LLC/SNAP headers
• The third integer identifies the protocol index.
Constraint
Indicates what type of constraint the switch should apply to packets caught
by the (port/protocol) filter, either
portMask or vlan. A value of portMask
will use the Allowed To Go To
mask to determine where the packets may
be forwarded. A value of
vlan classifies the packets as belonging to the
VLAN Vlan ID
.
Note: On the RoamAbout R2 Access Point, port/protocol
constraints are sometimes secondary to other kinds
of access controls.
Allowed To Go To
A port mask object indicating where packets that match this row's (port/
protocol) filter are allowed to go. It applies when Constraint
has a value of
portMask and this row is valid.