Specifications

Enterasys RoamAbout Wireless
Management Module Guide
Page 12
Document 5005
IP Address State
Set this button to establish the state of IP Address storage, either
volatile
or
non-volatile. A value of non-volatile causes the current IP address to
be stored in NVRAM.
Bridge Model
Set this button to establish the current Access Point bridge mode state.
The possible values are
workgroup, lan-to-lan, and lan-to-lan-hub. LAN-
to-LAN mode is the improved version used in 802.11 and which used to be
called full-bridge mode.
Upline Dump Mode
Set this button to
enabled to create a dump file on an Access Point crash.
Memory Size
A read-only field that displays the Access Point memory size in Mbytes.
Station Name
A read-write field that specifies the wireless station name sent out as part
of the beacon messages. This is valid only when a DS card is inserted in
the Access Point.
IP Subnet Mask
A read-write field that specifies the IP subnet mask for this Access Point.
RoamAbout MIB Point to Point Diagnostic View
Note: From the Icon Subviews menu for the
RoamAboutAP Device icon, select RoamAbout
MIB > Point to Point Diagnostic.
The point-to-point (PTP) diagnostic section of the
RoamAbout MIB only applies to non IEEE DS cards. The
following fields are provided.
Remote Station MAC
A read-write field that specifies the MAC address for the remote station to
participate in the point-to-point diagnostic test. To initiate a search for a
participating station, enter the broadcast address (
FF-FF-FF-FF-FF-FF).