Specifications

Configuring and Managing Ports
RoamAbout Mobility System Software Configuration Guide 4-3
Configuring for a Distributed DAP
ToconfigureaconnectionforaDistributedDAP(referredtoasaDAPintheCLI),usethe
followingcommand:
set dap dap-num serial-id serial-ID
model { AP3000 | AP4102 | AP1602 | AP1102 | AP1002 } radiotype {
11a | 11b| 11g }
Thedap‐numparameteridentifiestheDistributedAPconnectionfortheDAP.Therangeofvalid
connectionIDnumbersdependsontheRoamAboutSwitchmodel.
Table 4‐3liststherangesofvaliddap‐numvaluesforeachmodel.
Fortheserial‐idparameter,specifytheseria lIDoftheDAP.The
serialIDislistedontheDAP
case.TodisplaytheserialIDusingtheCLI,usetheshowversiondetailscommand.
Themodelandradiotypeparametershavethesameoptionsastheydowiththesetporttypeap
command.BecausetheRoamAboutSwitchdoesnotsupplypowertoan
indirectlyconnected
DAP,thesetdapcommanddoesnotusethepoeparameter. 
Examples
ToconfigureDistributedDAPconnection1forDAPmodelAP3000withserial‐ID0322199999,
typethefollowingcommand:
RBT-8100# set dap 1 serial-id 0322199999 model AP3000
success: change accepted.
ToconfigureDistributedDAPconnection2forDAPmodelAP3000 1withserial‐ID0322188888
andradiotype802.11a,typethefollowingcommand:
RBT-8100# set dap 2 serial-id 0322188888 model AP3000 radiotype 11a
success: change accepted.
Setting a Port for a Wired Authentication User
Tosetaportforawiredauthenticationuser,usethefollowingcommand:
set port type wired-auth port-list [tag tag-list] [max-sessions num]
[auth-fall-thru {last-resort | none | web-portal }]
Youmustspecifyaportlist.Optionally,youalsocanspecifyatag‐listtosubdividetheportinto
virtualports,setthemaximumnumberofsimultaneoususersessionsthatcanbeactiveonthe
port,andchangethefallthruauthenticationtype.
Bydefault,oneusersessioncanbe activeon
theportatatime.
Thefallthruauthenticationtypeisusediftheuserdoesnotsupport802.1Xandisnot
authenticatedbyMACauthentication.Thedefaultisnone,whichmeans theuserisautomatically
deniedaccessifneither802.1XauthenticationorMACauthenticationissuccessful.
Table 4-3 Valid dap-num Values
Switch Model Valid Range
RBT-8400 1 to 480
RBT-8200 1 to 360
RBT-8100 1 to 120