Specifications

Configuring and Managing Ports
4-2 Configuring and Managing Ports and VLANs
Table 4‐2listshowmanyDAPsyoucanconfigureonaRoamAboutSwitch,andhowmanyDAPs
aswitchcanboot.
Note: To configure for a DAP, refer to “Configuring for a Distributed DAP” on page 4-3 and
Chapter 9, ”Configuring Access Points”.
Table 4-1 Port Defaults Set By Port Type Change
Parameter
Port Type
Wired Authentication Network
VLAN
membership
Removed from all VLANs. You cannot
assign a wired authentication port to a
VLAN. MSS automatically assigns wired
authentication ports to VLANs based on
user traffic.
None.
Note: If you clear a port, MSS resets the
port as a network port but does not add the
port back to any VLANs. You must explicitly
add the port to the desired VLAN(s).
Spanning Tree
Protocol (STP)
Not applicable Based on the STP states of the VLANs the
port is in.
802.1X Uses authentication parameters
configured for users.
No authentication
Port groups Not applicable None
IGMP
snooping
Enabled as users are authenticated and
join VLANs.
Enabled as the port is added to VLANs.
Maximum user
sessions
1 (one) Not applicable
Table 4-2 Maximum DAPs Supported Per Switch
RoamAbout Switch
Model
Maximum DAPs
Configured Maximum That Can Be Booted
RBT-8400 480 40, 80, 120, depending on the license level
RBT-8200 360 24, 48, 72, depending on the license level
RBT-8100 120 24