Specifications

Administrative AAA Configuration Scenarios
2-6 Configuring AAA for Administrative and Local Access
• Usernamealiceandpasswordalicepassfor802.1X authentication;usernamebobandpassword
bobpassfor802.1Xauthentication
TheIPaddresses,usernames,andpasswordsinthisdocumentareexamples.Usevaluesthatare
appropriateforyourorganization. 
Ifyouconfiguretimeanddateparameters,youwillberequiredtoenteranamefor
thetimezone,
andthenenterthevalueofthetimezone(theoffsetfromUTC)separately.Youcanuseastringof
upto32alphabeticcharactersas thetimezonename.
Figure 2‐2showsanexample.UsersbobandalicecanaccessencryptedSSIDcorporateoneitherof
theRoamAboutAccessPoints.
Usersuser1anduser2canusethesameAPstoaccessunencrypted
SSIDpublic.AlthoughthesamehardwaresupportsbothSSIDsandsetsofusers,AAAensures
thatonlytheuserswhoareauthorizedtoaccessanSSIDcanaccessthatSSID.Usersofseparate
SSIDscanevenbein
thesameVLAN,astheyareinthisexample.
Figure 2-2 Single-Switch Deployment
RBT-aabbcc# quickstart
This will erase any existing config. Continue? [n]: y
Answer the following questions. Enter '?' for help. ^C to break out
System Name [RBT-8100]: RBT-Corp
Country Code [US]: US
System IP address []: 10.10.10.4
System IP address netmask []: 255.255.255.0
Default route []: 10.10.10.1
Do you need to use 802.1Q tagged default VLAN [Y/N]? Y: y
Specify the port number that needs to be tagged [1-2, <CR> ends config]: 2
Specify the tagged value for port [2] [<CR> ends config:] 100
Specify the port number that needs to be tagged [1-2, <CR> ends config]:
Admin username [admin]: RBTadmin
Admin password []: letmein
Do you wish to set the time? [y]: y
Enter the date (dd/mm/yy) []: 03/31/06
10.10.10.4
Port
3
RBT-8100-Corp
Port
2
Backbone
alice
Console
Internet
Corporate resources
user1
bob
user2