Specifications

Administrative AAA Configuration Scenarios
RoamAbout Mobility System Software Configuration Guide 2-5
Torunthequickstartcommand:
1. AttachaPCtotheRoamAboutSwitch’sserialconsoleport.(Usethesemodemsettings:9600
bps,8bits,1stop,noparity,hardwareflowcontroldisabled.)
2. PressEnterthreetimes,todisplayausernameprompt(Username:),apasswordprompt
(Password:),andthenacommandpromptsuch
asthefollowing:
RBT-aabbcc>
3. (Eachswitchhasauniquesystemnamethatcontainsthemodelnumberandthelasthalfof
theswitch’sMACaddress.)
4. Accesstheenabledlevel(theconfigurationlevel)oftheCLI:
RBT-aabbcc> enable
5. PressEnterattheEnterpasswordprompt.
6. Typequickstart.Thecommandasksyouaseriesofquestions.Youcantype?formorehelp.
Toquit,pressCtrl+C.
Oneofthequestionsthescriptasksisthecountrycode.Foralistofvalidcountrycodes,see
“Specifyingthe
CountryofOperation”onpage 9‐22.
Anotherquestionthescriptasksis,“Doyouwishtoconfigurewireless?”Ifyouanswery,the
scriptgoesontoaskyouforSSIDanduserinformation,forunencryptedandencryptedSSIDs.If
youanswern,thescriptgeneratesakeypairfor
SSHandthenends.
Quickstart Example
Thisexampleconfiguresthefollowingparameters:
•Systemname:RBT‐8100‐Corp
• Countrycode(regulatorydomain):US
•SystemIPaddress:10.10.10.4,onIPinterface10.10.10 .4255.255.255.0
•Defaultroute:10.10.10.1
• Administrativeuserrbtadmin,withpasswordletmein.Theonlymanagementaccess theswitch
allowsbydefaultisCLIaccessthroughtheserialconnection.
•SystemTimeand
dateparameters:
–
Date: 31st of March, 2006
–Time:6:58PM
– Timezone:EST(EasternStandardTime),withanoffsetof‐5hoursfromUniversal
CoordinatedTime(UTC)
• UnencryptedSSIDname:public
• Usernameuser1andpasswordpass1forWebAAA;usernameuser2andpasswordpass2for
WebAAA
•EncryptedSSIDname:corporate
Note: The quickstart script asks for an IP address and subnet mask for the system IP address, and
converts the input into an IP interface with a subnet mask, and a system IP address that uses that
interface. Likewise, if you configure this information manually instead of using the quickstart
command, you must configure the interface and system IP address separately.