Specifications

Configuring and Managing the System Log
A-8 Troubleshooting a RoamAbout Switch
Setting Telnet Session Defaults
Sessionloggingisdisabledbydefault,andtheeventlevelissettoinformation(info)orhigher.To
enableeventloggingtoTelnetsessionsandchangethedefaulteventseveritylevel,usethe
followingcommand:
set log sessions severity severity-level enable
(Forinformationonseveritylevels,seeTable A‐3onpage A‐5.)
Todisablesessionlogging,usethefollowingcommand:
set log sessions disable
Changing the Current Telnet Session Defaults
Bydefault,loginformationisnotsenttoyourcurrentTelnetsession,andtheloglevelissetto
information(info)orhigher.Tomodifytheseverityofevents loggedtoyourcurrentTelnet
session,usethefollowingcommandfromwithinthesession:
set log current severity severity-level
(Forinformationaboutseveritylevels,seeTable A‐3onpage A‐5.)
Toenablecurrentsessionlogging,typethefollowingcommand:
RBT-8100# set log current enable
success: change accepted
Todisablecurrentsessionlogging,typethefollowingcommand:
RBT-8100# set log current disable
success: change accepted
Logging to the Trace Buffer
Traceloggingisenabledbydefaultandstoresdebug‐leveloutputintheRAStracebuffer.To
modifytraceloggingtoaneventlevelhigherthandebug,usethefollowing command:
set log trace severity severity-level
Todisabletracelogging,usethefollowingcommand:
set log trace disable
success: change accepted.
(Todisplaythetracelog,see“StoppingaTrace”onpage A‐11.Forinformationaboutthetrace
function,see“RunningTraces”onpage A‐10.)