Specifications

Managing Configuration Files
RoamAbout Mobility System Software Configuration Guide 23-9
Filename Size Created
*boot0:bload 746 KB May 09 2004, 19:02:16
*boot0:ras030000.020 8182 KB May 09 2004, 18:58:16
boot1:ras030000.020 8197 KB May 21 2004, 18:01:02
Boot0: Total: 8928 Kbytes used, 3312 Kbytes free
Boot1: Total: 8197 Kbytes used, 4060 Kbytes free
===============================================================================
temporary files:
Filename Size Created
Total: 0 bytes used, 93537 Kbytes free
Removing a Subdirectory
Toremoveasubdirectoryfromnonvolatilestorage,usethefollowingcommand:
rmdir [subdirname]
Example
Toremovesubdirectorycorp2,typethefollowingexample:
RBT-8100# rmdir corp2
success: change accepted.
Managing Configuration Files
AconfigurationfilecontainsCLIcommandsthatsetuptheRoamAboutSwitch.Theswitchloads
adesignatedconfigurationfileimmediatelyafterloadingthesystemsoftwarewhenthesoftware
isrebooted.Youalsocanloadaconfigurationfilewhiletheswitchisrunningtochangethe
switch’sconfiguration.
WhenyouenterCLI
commandstomakeconfigurationchanges,thesechangesareimmediately
addedtothedevice’srunningconfigurationbutarenotsavedtotheconfigurationfile.
Thissectiondescribeshowtodisplaytherunningconfiguration andtheconfigurationfile,and
howtosaveandloadconfigura tionchanges.Aprocedureisalsoprovidedforresetting
the
RoamAboutSwitchtoitsfactorydefaultconfiguration.
Displaying the Running Configuration
TodisplaytheconfigurationrunningontheRoamAboutSwitch,usethefollowingcommand:
show config [area area] [all]
Theareaareaparameterlimitsthedisplaytoaspecificconfigurationarea.(Formoreinformation,
seetheRoamAboutMobilitySystemSoftwareCommandLineInterfaceReference.)
Theallparameterincludesallcommandsthataresetattheirdefaultvalues.Withouttheall
parameter,theshow configcommandlistsonlythoseconfigurationcommandsthat
seta
parametertoavalueother thanthedefault.