Specifications

Command Prompts
1-6 Using the Command-Line Interface
Port Lists
ThephysicalEthernetportsonaRoamA bou tSwitchcanbesetfor connectiontoAPs,
authenticatedwiredusers,orthenetworkbackbone.Youcanincludeasingleportormultiple
portsinoneMSSCLIcommandbyusing theap propriatelistformat.
TheportsonaRoamAboutSwitcharenumbered1
through4.Noport 0existsontheswitch.You
canincludeasingleportormultipleportsinacommandthatincludesportport‐list.Useoneofthe
followingformatsforport‐list:
•Asingleportnumber.Forexample:
RBT-8100# set port enable 1
•Acomma‐separatedlistofportnumbers,withnospaces.Forexample:
RBT-8100# show port poe 1,2,4,
•Ahyphen‐separatedrangeofportnumbers,withnospaces.Forexample:
RBT-8100# reset port 1-3
•Anycombinationofsinglenumbers,lists,andranges.Hyphenstakeprecedenceover
commas.Forexample:
RBT-8100# show port status 1-2,4
Virtual LAN Identification
ThenamesofvirtualLANs(VLANs),whichareusedinMobilityDomain™communications,are
setbyyouandcanbechanged. Incontrast,VLANIDnumbers,whichtheRoamAboutSwitchuses
locally,aredeterminedwhentheVLANisfirstconfiguredandcannotbechanged.Unless
otherwiseindicated,youcanrefer
toaVLANbyeitheritsVLANnameoritsVLANnumber.CLI
setandshowcommandsuseaVLAN’snameornumbertouniquelyidentifytheVLANwithin
theRoamAboutSwitch.