Specifications

Configuring 802.1X Authentication
RoamAbout Mobility System Software Configuration Guide 17-17
Bonded Auth Configuration Example
ToconfigureBondedAuth:
• Configureseparateauthenticationrulesforthemachineandfortheuser(s).
•SettheBondedAuthperiod.
•Verifytheconfigurationchanges.
Thefollowingcommandsconfiguretwo802.1XauthenticationrulesforaccesstoSSIDmycorp.The
firstruleisforauthenticationofalltrustedlaptopPCsatmycorp.com(host/*‐laptop.mycorp.com).
Thesecondruleisforbondedauthenticationofallusersatmycorp.com(*.mycorp.com).Both
rulesusepass‐throughastheprotocol,anduseRADIUSservergroupradgrp1.
RBT-8100# set authentication dot1x ssid mycorp host/*-laptop.mycorp.com pass-
through radgrp1
success: change accepted.
RBT-8100# set authentication dot1x ssid mycorp *.mycorp.com bonded pass-through
radgrp1
success: change accepted.
ThefollowingcommandsetstheBondedAuthperiodto60seconds,toallowti meforWEPusers
toreauthenticate:
RBT-8100# set dot1x bonded-period 60
success: change accepted.
Displaying Bonded Auth Configuration Information
TodisplayBondedAuthconfigurationinformation,usethefollowingcommand:
show dot1x config
Example
Inthefollowingexample,bob.mycorp.comusesBondedAuth,andtheBondedAuthperiodisset
to60seconds.
RBT-8100# show dot1x config
802.1X user policy
----------------------
'host/bob-laptop.mycorp.com' on ssid 'mycorp' doing PASSTHRU
'bob.mycorp.com' on ssid 'mycorp' doing PASSTHRU (bonded)
802.1X parameter setting
---------------- -------
supplicant timeout 30
auth-server timeout 30
quiet period 60
transmit period 5
reauthentication period 3600
maximum requests 2
key transmission enabled