Specifications

Changing QoS Settings
RoamAbout Mobility System Software Configuration Guide 12-15
Changing QoS Settings
YoucanchangethesettingsofthefollowingQoSoptions:
•QoSmode
•U‐APSDsupport
•CACstateandmaximumnumberofsessions
•Broadcastcontrol
•StaticCoSstateandCoSvalue
•DSCP‐CoSmappings
TheQoSmodeisconfigurableonaradio‐profilebasis.CACandstaticCoSareconfigurableona
service‐profilebasis.
DSCP‐CoSmappingisconfigurableonaglobalswitchbasis.
Changing the QoS Mode
ThedefaultQoSmodeisWM M.TochangetheQoSmodeonaradioprofile,usethefollowing
command:
set radio-profile name qos-mode {svp | wmm}
Example
ThefollowingcommandchangestheQoSmodeforradioprofilerp1toSVP:
RBT-8100# set radio-profile rp1 qos-mode svp
success: change accepted.
Enabling U-APSD Support
U‐APSDsupportisdisabledbydefault.Toenableitonaradioprofile,usethefollowing
command:
set radio-profile name wmm-powersave {enable | disable}
Forexample,thefollowingcommandenablesU‐APSDonradioprofilerp1:
RBT-8100# set radio-profile rp1 qos-mode svp
success: change accepted.
Configuring Call Admission Control
ToconfigureCACforanSSID,enablethefeatureontheSSID’sserviceprofile.Whenenabled,
CAClimitsthenumberofactivesessionsaradiocanhaveto14bydefault.Youcanchangethe
maximumnumberofsessionstoavaluefrom0to100.
Note: SVP configuration requires ACLs to set CoS, in addition to the SVP QoS mode. (For
information, see “Enabling SVP Optimization for SpectraLink Phones” on page 15-24.)