Specifications

Displaying RF Auto-Tuning Information
RoamAbout Mobility System Software Configuration Guide 11-9
Displaying RF Auto-Tuning Information
YoucandisplaytheRF Auto‐Tuning configuration,alistofRFneighbors,andthevaluesofRF
attributes.(Forinformationaboutthefieldsintheoutput,seetheRoamAboutMobilitySystem
SoftwareCommandLineInterfaceReference.)
Displaying RF Auto-Tuning Settings
TodisplaytheRF Auto‐Tuningsettingsthatyoucanconfigureinaradioprofile,usethefollowing
command:
show radio-profile {name | ?}
Enteringshowradio‐profile?displaysalistofradioprofiles.
Examples
TodisplaytheRF Auto‐Tuningandothersettings inthedefaultradioprofile,typethefollowing
command:
RBT-8100# show radio-profile default
Beacon Interval: 100 DTIM Interval: 1
Max Tx Lifetime: 2000 Max Rx Lifetime: 2000
RTS Threshold: 2346 Frag Threshold: 2346
Long Preamble: no Tune Channel: yes
Tune Power: no Tune Channel Interval: 3600
Tune Power Interval: 600 Power ramp interval: 60
Channel Holddown: 300 Countermeasures: none
Active-Scan: yes RFID enabled: no
WMM Powersave: no QoS Mode: wmm
No service profiles configured.
TodisplaytheRF Auto‐Tuningsettingsthatyoucanconfigureonanindividualradio,usethe
followingcommands:
show ap config [port-list [radio {1 | 2}]]
show dap config [dap-num [radio {1 | 2}]]
TodisplaytheRF Auto‐Tuningandotherindividualradiosettingsonbothradiosonthe
Distributedaccesspointconfiguredonconnection1,typethefollowingcommand:
RBT-8100# show dap config 1
Dap 1: serial-id: 12345678, AP model: AP3000, bias: high, name: DAP01
fingerprint: b4:f9:2a:52:37:58:f4:d0:10:75:43:2f:45:c9:52:c3
boot-download-enable: YES
Radio 1: type: 802.11g, mode: disabled, channel: 6
tx pwr: 1, profile: default
Radio 2: type: 802.11a, mode: disabled, channel: 36
tx pwr: 1, profile: default