Specifications

RF Auto-Tuning Overview
RoamAbout Mobility System Software Configuration Guide 11-5
ARF Auto-Tuning Parameters
Table 11‐1liststheRF Auto‐Tuningparametersandtheirdefaultsettings.
Table 11-1 Defaults for RF Auto-Tuning Parameters
Parameter Default Value
Radio Behavior When Parameter Set To
Default Value
Radio profile parameters
channel-config enable When the radio is first enabled,
RF Auto-Tuning sets the channel based on
the channels in use on neighboring access
points.
channel-interval 3600 Every 3600 seconds, MSS examines the
RF information gathered from the network
and determines whether the channel needs
to be changed to compensate for RF
changes.
channel-holddown 900 MSS maintains the channel setting on a
radio for at least 900 seconds regardless of
RF changes.
channel-lockdown disabled MSS continues to dynamically change
channels if needed based on network
conditions.
power-config disable MSS uses the highest power level allowed
for the country of operation or the highest
supported by the hardware, whichever is
lower.
power-interval 300 Every 300 seconds, MSS examines the RF
information gathered from the network and
determines whether the power needs to be
changed to compensate for RF changes.
power-lockdown disabled MSS continues to dynamically change
power settings if needed based on network
conditions.
power-ramp-interval 60 When RF Auto-Tuning determines that
power should be increased or decreased,
MSS changes the power by 1 dBm every
60 seconds until the power setting is
reached.
Individual radio parameter
max-power Maximum
allowed for
country of
operation
RF Auto-Tuning never sets a radio’s power
to a level that is higher than the maximum
allowed for the country of operation
(countrycode).