Specifications

Configuring WEP
10-16 Configuring User Encryption
Figure 10-4 Encryption for Dynamic and Static WEP
Setting Static WEP Key Values
MSSsupportsdynamicWEPautomatically.ToenablestaticWEP,configureWEPkeysandassign
themtounicastandmulticasttraffic.Youcan setthevaluesofthefourstaticWEPkeys,then
specifywhichofthekeystouseforencryptingmulticastframesandunicastframes.Ifyoudothis,
MSS
continuestosupportdynamicWEPinadditiontostaticWEP.
TosetthevalueofaWEPkey,usethefollowingcommand:
set service-profile name wep key-index num key value
Thekey‐indexnumparameterspecifiestheindexyouareconfiguring.Youcanspecifyavalue
from1through4.
Thekeyvalueparameterspecifiesthehexadecimalvalueofthekey.Typea10‐characterASCII
string(representinga5‐bytehexadecimalnumber)ortypea26‐characterASCIIstring
(representing
a13‐bytehexa decimalnumber).Youcanusenumbersorletters.ASCIIcharactersin
thefollowingrangesaresupported:
•0to9
•AtoF
•atof
User D
TKIP
WPA
User C
Static WEP
-Unicast key = a1b1c1d1e1
-Multicast key = a2b2c2d2e2
Non
-
WPA
User B
Dynamic 40-bit WEP
WPA
User A
Dynamic WEP
Non-WPA
WPA disabled
Dynamic WEP enabled
Static WEP enabled
-Unicast key = a1b1c1d1e1
-Multicast key = a2b2c2d2e2
RoamAbout Switch
AP
Layer 2
Note: If you plan to use static WEP, do not map more than 8 service profiles that contain static WEP
keys to the same radio profile.