Specifications

Disabling or Reenabling Radios
9-52 Configuring Access Points
Disabling or Reenabling Radios
Youcandisableorreenableradiosonaradioprofilebasisorindividualbasis.Youalsocanreseta
radiotoitsfactorydefaultsettings.
(Todisableorreenableradioswhenassigningorremovingaradioprofile,referto“Assigninga
RadioProfileandEnablingRadios”onpage 9‐51.)
Enabling or Disabling Individual Radios
Todisableorreenableanaccesspointradio,usethefollowingcommand:
set {ap port-list | dap dap-num} radio {1 | 2} mode {enable | disable}
Example
Todisableradio2onport1and3,typethefollowingcom mand:
RBT-8100# set ap 1,3 radio 2 mode disable
success: change accepted.
Disabling or Reenabling All Radios Using a Profile
Todisableorreenableallradiosthatareusingaradioprofile,usethefollowingcommand:
set radio-profile name [mode {enable | disable}]
Examples
Thefollowingcommandenablesallradiosthatuseradioprofilerp1:
RBT-8100# set radio-profile rp1 mode enable
success: change accepted.
Thefollowingcommandsdisableallradiosthatuseradioprofilerp1,changethebeaconinterval,
thenreenabletheradios:
RBT-8100# set radio-profile rp1 mode disable
success: change accepted.
RBT-8100# set radio-profile rp1 beacon-interval 200
success: change accepted.
RBT-8100# set radio-profile rp1 mode enable
success: change accepted.