Specifications

Configuring Access Points
RoamAbout Mobility System Software Configuration Guide 9-29
Specifying the Radio Profile Used by the Auto-AP Profile
TheAuto‐APProfileusesradioprofiledefaultbydefault.Touseanotherradioprofileinstead,use
thefollowingcommand:
set dap auto radio {1 | 2} radio-profile name mode {enable | disable}
Example
ThefollowingcommandchangestheAuto‐APProfiletouseradioprofileautodap1forradio1:
RBT-8100# set dap auto radio 1 radio-profile autodap1
success: change accepted.
Displaying Status Information for APs Configured by the Auto-AP Profile
TodisplaystatusinformationforAPsconfiguredbytheAuto‐APProfile,typethefollowing
command:
RBT-8100# show dap status auto
Dap: 100 (auto), IP-addr: 10.8.255.6 (vlan 'default'), AP model: AP3000,
manufacturer: Enterasys, name: DAP100
====================================================
State: operational (not encrypted)
CPU info: IBM:PPC speed=266666664 Hz version=405GPr
id= ram=33554432
s/n=0333703027 hw_rev=A3
Uptime: 18 hours, 36 minutes, 27 seconds
Radio 1 type: 802.11g, state: configure succeed [Enabled] (802.11b protect)
operational channel: 1 operational power: 14
base mac: 00:0b:0e:00:d2:c0
bssid1: 00:0b:0e:00:d2:c0, ssid: public
bssid2: 00:0b:0e:00:d2:c2, ssid: employee-net
bssid3: 00:0b:0e:00:d2:c4, ssid: mycorp-tkip
Radio 2 type: 802.11a, state: configure succeed [Enabled]
operational channel: 64 operational power: 14
base mac: 00:0b:0e:00:d2:c1
bssid1: 00:0b:0e:00:d2:c1, ssid: public
bssid2: 00:0b:0e:00:d2:c3, ssid: employee-net
bssid3: 00:0b:0e:00:d2:c5, ssid: mycorp-tkip
TheoutputdisplaysautonexttotheAPnumbertoindicatethattheAPwasconfiguredusinga
Auto‐APProfile.
Note: You must configure the radio profile before you can apply it to the Auto-AP Profile.