Specifications

Configuring Access Points
9-28 Configuring Access Points
APsthatreceivetheirconfigurationsfromtheAuto‐APProfilealsoreceivetheradiosettingsfrom
theradioprofileusedbytheAuto‐APProfile.Likewise,theSSIDsandencryptionsettingscome
fromtheserviceprofilesmappedtotheradioprofile.Tousearadioprofileotherthandefault,you
mustspecifytheradioprofileyouwanttouse.(Referto“SpecifyingtheRadioProfileUsedbythe
Auto‐APProfile”onpage 9‐29.)
Changing AP Parameter Values
ThecommandsforconfiguringAPandradioparametersfortheAuto‐APProfilearethesameas
thecommandsforconfiguringanindividualAP.InsteadofspecifyinganAPnumberwiththe
command,specifyauto.Formoreinformationaboutthesyntax,refertothe“AccessPoint
Commands”chapterofthe
RoamAboutMobilitySystemSoftwareCommandLineInterfaceReference
Guide.
APParameters:
set dap auto bias {high | low}
set dap auto blink {enable | disable}
set dap auto force-image-download {enable | disable}
set dap auto group name
set dap auto mode {enable | disable}
set dap auto persistent [dap-num | all]
set dap auto upgrade-firmware {enable | disable}
RadioParameters:
set dap auto radiotype {11a | 11b| 11g}
set dap auto radio {1 | 2} auto-tune max-power power-level
set dap auto radio {1 | 2} auto-tune max-retransmissions retransmissions
set dap auto radio {1 | 2} mode {enable | disable}
set dap auto radio {1 | 2} radio-profile name mode {enable | disable}
Enabling the Auto-AP Profile
ToenabletheAuto‐APProfileforautomaticAPconfiguration,typethefollowingcommand:
set dap auto mode enable
radiotype 11g
(or 11b for country codes where
802.11g is not allowed)
Table 9-6 Configurable Auto-AP Profile Parameters for APs (continued)
Parameter Default Value