Specifications

Configuring Access Points
RoamAbout Mobility System Software Configuration Guide 9-27
Configuring a Auto-AP Profile
TheAuto‐APProfileforAPconfigurationislikeanindividualAPconfiguration,exceptthe
configurationhasthenameautoinsteadofaAPnumber.
Examples
TocreateaAuto‐APProfileforautomaticAPconfiguration,typethefollowing command:
RBT-8100# set dap auto
success: change accepted.
TodisplaytheAPsettingsintheAuto‐APProfile,typethefollowingcommand:
RBT-8100# show dap config auto
Dap auto: mode: disabled bias: high
fingerprint
boot-download-enable: YES
force-image-download: NO
Radio 1: type: 802.11g, mode: enabled, channel: dynamic
tx pwr: 15, profile: default
auto-tune max-power: default
Radio 2: type: 802.11a, mode: enabled, channel: dynamic
tx pwr: 11, profile: default
auto-tune max-power: default
TheexampleshowsthedefaultsfortheAPparametersyoucanconfigureintheAuto‐APProfile.
Table 9‐6liststheconfigurableAuto‐APProfileAuto‐APProfileparametersandtheirdefaults.The
onlyparameterthatrequiresconfigurationistheAuto‐APProfilemode.TheAuto‐APProfileis
disabledbydefault.
TousetheAuto‐APProfiletoconfigureAPs,youmustenabletheAuto‐AP
Profile.(Referto“EnablingtheAuto‐APProfile”onpage 9‐28.)
Table 9-6 Configurable Auto-AP Profile Parameters for APs
Parameter Default Value
AP Parameters:
bias high
blink
(Not shown in show dap config output)
disable
force-image-download disable (NO)
group (load balancing group) none
mode disabled
persistent none
upgrade-firmware (boot-download-enable) enable (YES)
Radio Parameters:
radio num auto-tune max-power default
radio num mode enabled
radio num radio-profile default