Specifications

Configuring Access Points
9-22 Configuring Access Points
Specifying the Country of Operation
YoumustspecifythecountryinwhichyouplantooperatetheRoamAboutSwitchanditsaccess
points.MSSdoesnotallowyoutoconfigureorenabletheaccesspointradiosuntilyouspecifythe
countryofoperation(refertoTable 9‐5onpage 9‐22).
Tospecifythecountry,usethe
followingcommand:
set system countrycode code
Forthecountry,youcanspecifyoneofthecodeslistedinTable 9‐5.
Note: In countries where Dynamic Frequency Selection (DFS) is required, MSS performs the
appropriate check for radar. If radar is detected on a channel, the AP radio stops using the channel
for the amount of time specified in the specified country’s regulations. MSS also generates a log
message to notify you when this occurs.
Table 9-5 Country Codes
Country Code
Algeria DZ
Argentina AR
Australia AU
Austria AT
Belgium BE
Bolivia BO
Brazil BR
Bulgaria BG
Canada CA
Chile CL
China CN
Colombia CO
Costa Rica CR
Cote d’Ivoire CI
Croatia HR
Cyprus CY
Czech Republic CZ
Denmark DK
Dominican Republic DO
Ecuador EC