Specifications

Configuring Access Points
RoamAbout Mobility System Software Configuration Guide 9-21
Configuring Access Points
Toconfigureaccesspoints,performthefollowingtasks,inthisorder:
•Specifythecountryofoperation.(referto“SpecifyingtheCountryofOperation”on
page 9‐22.)
• ConfigureaAuto‐APProfileforautomaticconfigurationofAPs.(referto“Configuringan
Auto‐DAPProfileforAutomaticAPConfiguration”onpage 9‐26.)
• Configuresecurity.(referto“ConfiguringAP‐Roam AboutSwitchSecurity”onpage 9‐35.)
• ConfigureaserviceprofiletosetSSIDandencryptionparameters.(referto“Configuringa
ServiceProfile”onpage 9‐39.)
• Configurearadioprofile.(referto“ConfiguringaRadioProfile”onpage 9‐43.)
•Ifrequired,configurethechannel,
transmitpower,andexternalantennatypeoneachradio.
(referto“ConfiguringRadio‐SpecificParameters”onpage 9‐49.)
•Maptheradioprofiletoaserviceprofile.(referto“MappingtheRadioProfiletoService
Profiles”onpage 9‐51.)
• Assigntheradioprofiletoradiosandenabletheradios.(refer
to“AssigningaRadioProfile
andEnablingRadios”onpage 9‐51.)