Specifications

AP Overview
RoamAbout Mobility System Software Configuration Guide 9-19
(Toconfigurearadioprofile,referto“ConfiguringaRadioProfile”onpage 9‐43.)
RF Auto-Tuning
TheRF Auto‐TuningfeaturedynamicallyassignschannelandpowersettingstoAPradios,and
adjuststhosesettingswhenneeded.RF Auto ‐Tuningcanperformthefollowingtasks:
• AssigninitialchannelandpowersettingswhenanAPradioisstarted.
• PeriodicallyassesstheRFenvironmentandchangethechannelorpowersettingif
needed.
• Changethetransmitdatarateorpowertomaintainatleasttheminimumdataratewithall
associatedclients.
Bydefault,RF Auto‐Tuningisenabledforchannelconfigurationbutdisabledfor power
configuration.
(Formoreinformation,refertoChapter 11,”Configuring RFAuto‐Tuning”.)
Default Radio Profile
MSScontainsonedefaultradioprofile,nameddefault.Toapplycommonparameterstoradios,
youcanmodifythedefaultprofileorcreateanewone.Whenyoucreateanewprofile,theradio
parametersintheprofilearesettotheirfactorydefaultvalues.
preamble-length short Advertises support for short 802.11b preambles, accepts
either short or long 802.11b preambles, and generates
unicast frames with the preamble length specified by the
client.
Note: This parameter applies only to 802.11b/g radios.
qos-mode wmm Classifies and marks traffic based on 802.1p and DSCP,
and optimizes forwarding prioritization of AP radios for
Wi-Fi Multimedia (WMM).
rfid-mode disable Radio does not function as a location receiver in an
AeroScout Visibility System.
rts-threshold 2346 Transmits frames longer than 2346 bytes by means of the
Request-to-Send/Clear-to-Send (RTS/CTS) method.
service-profile No service
profiles defined
You must configure a service profile. The service profile
sets the SSID name and other parameters
wmm-powersave disabled Requires clients to send a separate PSpoll to retrieve each
unicast packet buffered by the AP radio.
Table 9-3 Defaults for Radio Profile Parameters
Parameter Default Value Radio Behavior When Parameter Set To Default Value