Specifications

AP Overview
RoamAbout Mobility System Software Configuration Guide 9-17
(Toconfigureaserviceprofile,referto“ConfiguringaServiceProfile”onpage 9‐39.)
Public and Private SSIDs
EachradiocansupportthefollowingtypesofSSIDs:
•EncryptedSSID—ClientsusingthisSSIDmustuseencryption.UsetheencryptedSSIDfor
securedaccesstoyourenterprisenetwork.
•ClearSSID—ClientsusingthisSSIDdonotuseencryption.UsetheclearSSIDforpublic
accesstononsecureportionsofyournetwork.
TheAP3000
has8macaddressesperradioandcanthereforesupportupto8SSIDs,withone
MACaddressassignedtoeachSSIDasitsBSSID.AnaccesspointʹsMACaddressblockislistedon
alabelonthebackoftheaccesspoint.IftheAPisalreadydeployed
andrunningonthenetwork,
youcandisplaytheMACaddressassignmentsbyusingtheshow{ap|dap}statuscommand.
web-portal-acl portalacl
Note: This is the
default only if the
fallthru type on the
service profile has
been set to web-
portal. Otherwise,
the value is
unconfigured.
If set to portalacl and the service profile fallthru is set to
web-portal, radios use the portalacl ACL to filter traffic for
Web Portal users during authentication.
If the fallthru type is web-portal but web-portal-acl is set to
an ACL other than portalacl, the other ACL is used.
If the fallthru type is not web-portal, radios do not use the
web-portal-acl setting.
web-portal-form Not configured For Web Portal WebAAA users, serves the default login web
page or, if configured, the SSID-specific login web page.
web-portal-
session-
timeout
5 Allows a Web Portal WebAAA session to remain in the
Deassociated state 5 seconds before being terminated
automatically.
wep key-index No keys defined Uses dynamic WEP rather than static WEP.
Note: If you configure a WEP key for static WEP, MSS
continues to also support dynamic WEP.
wep active-
multicast-index
1 Uses WEP key 1 for static WEP encryption of multicast traffic
if WEP encryption is enabled and keys are defined.
wep active-
unicast-index
1 Uses WEP key 1 for static WEP encryption of unicast traffic if
WEP encryption is enabled and keys are defined.
wpa-ie disable Does not use the WPA IE in transmitted frames.
Table 9-2 Defaults for Service Profile Parameters (continued)
Parameter Default Value Radio Behavior When Parameter Set To Default Value