Specifications

AP Overview
9-2 Configuring Access Points
Figure 9-1 Example Enterasys Network
Toconfigureaccesspoints,performthefollowingtasks,inthisorder:
•Specifythecountryofoperation.
• ConfigureAPconnections.
•Ifrequired,configureradio‐specificparameters,whichincludethechannelnumber,transmit
power,andexternalantennamodel.
• ConfigureSSIDandencryptionsettingsinaserviceprofile.
•Maptheserviceprofiletoaradio
profile,assigntheradioprofiletoradios,andenablethe
radios.
Note: You do not need to set channels and power if you use RF Auto-Tuning to set these values.
You do not need to specify an external antenna model unless a radio uses an external antenna.
However, if you do install an external antenna, you must ensure that the external antenna model
parameter you specify exactly matches the external antenna that is attached to the AP’s external
antenna port, in order to meet regulatory requirements
Router
Router
10.10.40.19/24
10.10.20.19/24
10.10.30.19/24
RADIUS
servers
10.10.70.20
10.10.70.40
10.10.60.18/24
10.10.60.19/24
RASM
Layer 2
System IP address
10.10.40.4
RAS2
Layer 2
10.10.10.19/24
System IP address
10.10.50.4
RAS3
Layer 2
serial-id 0322199998
serial-id 0322199999
10.10.50.19/24
external antenna
model ANT-1060
AP
AP