Specifications

Configuring a Network Domain
RoamAbout Mobility System Software Configuration Guide 8-7
Youcanenterthiscommandmultipleti mesonaRoamAboutSwitch,specifyingdifferent
NetworkDomainseedswithdifferentaffinity values.Theaffinityvaluecanrangefrom1–10,
with10beingthehighestaffinity.Thedefaultaffinityvalueis5.
Examples
ThefollowingcommandsetsthecurrentRoamAboutSwitchasamemberofaNetworkDomain
wheretheRoamAboutSwitchwithIPaddress192.168.9.254isaseed:
RBT-8200# set network-domain mode member seed-ip 192.168.9.254
success: change accepted.
Tospecify10.8.107.1asanadditionalNetworkDomainseedfortheRoamAboutSwitchtoconnect
toifthe192.168.9.254seedisunavailable,enterthefollowingcommand:
RBT-8200# set network-domain mode member seed-ip 10.8.107.1 affinity 2
success: change accepted.
Displaying Network Domain Information
ToviewthestatusofNetworkDomainsconfiguredontheRoamAboutSwitch,usetheshow
network‐domaincommand.Theoutputofthecommanddiffersbasedonwhetherthe
RoamAboutSwitchisamemberofaNetworkDomainoraNetworkDomainseed.
Examples
ARoamAboutSwitchthatisaNetworkDomainmemberonly,outputsuchasthefollowingis
displayed:
RBT-8200# show network-domain
Member Network Domain name: California
Member State Mode Mobility-Domain
--------------- ------------- ------ ---------------
10.8.107.1 UP SEED default
OnaRoamAboutSwitchthatisaNetworkDomainseed,informationisdisplayedaboutthe
NetworkDomainseedswithwhichtheRoamAboutSwitchhasapeerrelationship,aswellasthe
NetworkDomainsofwhichtheRoamAboutSwitchisamember.Forexample:
RBT-8200# show network-domain
Network Domain name: California
Peer State
--------------- -------------
10.8.107.1 UP
Member State Mode Mobility-Domain
--------------- ------------- ------ ---------------
10.1.0.0 DOWN SEED
Member Network Domain name:
Member State Mode Mobility-Domain
--------------- ------------- ------ ---------------
10.8.107.1 UP MEMBER default
Note: If the Network Domain seed is also intended to be a member of the Network Domain, you
must also enter this command on the Network Domain seed itself.