Specifications

Configuring and Managing Time Parameters
5-24 Configuring and Managing IP Interfaces and Services
Changing the NTP Update Interval
Thedefaultupdateintervalis64seconds.Tochangetheupdateinterval,usethefollowing
command:
set ntp update-interval seconds
Youcanspecifyanintervalfrom16through1024seconds.
Example
TochangetheNTPupdateintervalto128seconds,typethefollowingcommand:
RBT-8100# set ntp update-interval 128
success: change accepted.
Resetting the Update Interval to the Default
Toresettheupdateintervaltothedefaultvalue,usethefollowingcommand:
clear ntp update-interval
Enabling the NTP Client
TheNTPclientisdisabledbydefault.ToenabletheNTPclient,usethefollowingcommand:
set ntp {enable | disable}
Displaying NTP Information
TodisplayNTPinformation,usethefollowingcommand:
show ntp
Example
RBT-8100> show ntp
NTP client: enabled
Current update-interval: 20(secs)
Current time: Sun Feb 29 2004, 23:58:12
Timezone is set to 'PST', offset from UTC is -8:0 hours.
Summertime is enabled.
Last NTP update: Sun Feb 29 2004, 23:58:00
NTP Server Peer state Local State
---------------------------------------------------
192.168.1.5 SYSPEER SYNCED
TheTimezoneandSummertimefieldsaredisplayedonlyifyouchangethetim ezoneorenable
summertime.
Formoreinformationaboutthefieldsintheoutput,seetheRoamAboutMobilitySystemSoftware
CommandLineInterfaceReference.