Installation guide

Mounting in a Four-Post System
RBT-8100 Wireless Switch Installation Guide 2-3
c. Repeatstepaandstepbtotheoppositesideofthechassis.
Figure 2-3 Attaching a Chassis Disk to the Chassis
4. AttachrearbracketstotherearpostsasshowninFigure 2‐4.
a. Attachanutbar(B)ontheinsideofthetworearrackpostsusingscrews(A).Donot
completelytightenthescrews,leavethem
looseenoughtoallowinsertionofthebrackets
instepb.
b. Inserttheslottedfootofarearbracket(C)betweeneachnutbarandpost.
c. Alignthefaceofthebracketfootwiththeedgeoftherackpostandfirmlytightenthe
screws.
Figure 2-4 Attaching a Rear Bracket to a Rear Post
A
B
A. Chassis disk
B. #6-32 x 3/16-inch screw
B
C
A
A. #10-32 x 1/2-inch screw
B . Nut bar
C. Rear bracket