Installation guide

Mounting in a Four-Post System
2-2 Bracket Kit Installation
Figure 2-1 Removing a Handle from the Chassis
2. AttachthechassisbracketstothechassisasshowninFigure 2‐2.
a. Placeachassisbracketalongonesideofthechassisinthefront‐mountposition(A).
b. Aligntheholes(B)inthebracketwiththetabs(C)onthechassisandplacethebracket
againstthechassis.Slide the
brackettowardthefrontofthechassistotheendoftravel.
c. Fastenthebrackettothechassisusingascrew(D).
d. Repeatstepathroughstepctoattachachassisbrackettotheothersideofthechassis.
Figure 2-2 Installing a Chassis Bracket in the Front-Mount Position
3. AttachdiskstothechassisasshowninFigure 2‐3.
a. Attach
achassisdisk(A)atthesideofthechassistowardstherear.
b. Installthescrewandtighten.
D
B
C
A
A. Chassis bracket in front-mount position
B. Bracket holes
C. Chassis tabs
D. #6-32 x 3/16-inch screw