Installation guide

RBT-8100 Wireless Switch Installation Guide 2-1
2
Bracket Kit Installation
ThebracketkitallowsyoutoinstalltheRBT‐8100WirelessSwitchintomostfour‐postrackand
cabinetsystems.TheonlytoolrequiredisaPhillipsscrewdriver.
Kit Contents
•Twochassisbrackets
•Tworearbrackets
•TwoLbrackets
•1fastenerpackthatincludesthefollowing:
Mounting in a Four-Post System
Tomountthechassisinafour‐postsystem,performthefollowingsteps:
1. Ifyourchassishaschassishandlesattached,removethescrewsasshowninFigure 2‐1.Setthe
handlesandscrewsasideforreattachmentlater.
A
B
C D
E
F
A. Eight #10-32 x 1/2-inch screws
B. Four #6-32 x 3/16-inch screws
C. Two #10-32 x 7/8-inch screws
D. Two handle spacers
E. Four nut bars
F. Two chassis disks