Installation guide

Surface Wallmount Installation
3-12 Installing the Access Point
10. Connect the 10BaseT Ethernet network
cable.
If you are using the remote power
feature, label the end of the cable to the
AP with: CAUTION: Ethernet cable
contains power. Do not use for other
devices.
If you are not using remote power, install
the power module/redundant power
module, if used; refer to Power Module
Installation on page 2-6.
11. Connect the power module into an AC
outlet.
12. Verify power on by observing that some
of the AP LEDs are flashing or lit.
APH_31
Power
Connector
Ethernet
Cable
Connector
S
2
S
1