Installation guide

Wall/Ceiling Outlet Box Installation
3-6 Installing the Access Point
11. Install the power module/redundant power module, if
used.
Refer to Power Module Installation on page 2-6.
Connect the output of the power module/redundant
power module to the AP.
12. Connect the power module into an AC outlet.
13. Verify power on by observing that some of the AP LEDs
are flashing or lit.
14. Secure the cover:
— Position the cover over the AP.
— Make sure the cover clears the antenna plug.
— Push the cover down until all four snaps are secured.
S
2
S
1
APH_27
S
2
S
1
M
A
C
A
D
D
S
N
T
U
V
Snaps (4)
APH_28G