User`s guide

Configure Employee Access Services
RoamAbout Switch Manager User’s Guide 3-5
Example: Configure Employee Access
ThefollowingdetailedstepsprovideanexampleofhowtoconfigureEmployeeservices.Youwill:
•“CreateaRadioProfile”onpage 3 ‐5
•“ConfigureRADIUSServers”onpage 3‐7
•“CreateaServiceProfilefor802.1XAccess”onpage 3‐10
•“SetUpVLANsonRoamAboutSwitches”onpage 3‐15
Ingeneral,
thesesamestepsarerequiredtoconfigureotherservices,too.Youcanreferbacktothis
section,usingthesummarylistorthetasktable,withconfigurationoptionsfor“ConfigureGuest
AccessServices”onpage 3‐18or“ConfigureVoiceoverWirelessIPService”onpage 3‐33.
Create a Radio Profile
Configurearadioprofiletosetattribu testhatapplytomultipleradios.Ratherthanconfiguring
eachradioindividually,applytheradioprofiletomultipleradios.Serviceprofilesaremappedto
radioprofiles.
TheradioprofilecancontainRFAuto‐TuningsettingsandIEEE802.11settingsthatcontrolhow
thedatais
receivedandtransmitted.
APs(andconsequently,radios)needtobeaddedtoRASMaftercreatingaradioprofile.Formore
informationaboutaddingradios,refertooneofthefollowing:
• Chapter 4,”UsingRFAuto‐Tuning”
• Chapter 5,”UsingRFAuto‐TuningwithModelling”
• Chapter 6,”UsingRFPlanning”
TocreateaRadio
Profile:
1. SelectConfigurationonthetoolbar.
2. IntheOrganizerpanel,expandtheRoamAboutSwitch.
3. ExpandWireless,thenselectRadioProfiles.
4. IntheTaskListpanel,selectRadioProfile.
TheCreateRadioProfilewizardisdisplayed.