User`s guide

Installing RASM
RoamAbout Switch Manager User’s Guide 1-11
Configure RASM Services
YoucanchangethepropertiesofRASMServices.
ToconfigureRASMServices:
1. SelectServices>Setup.RASMServiceswillopeninyourdefaultbrowser
2. ConfigurethefollowingoptionsbyclickingServerSettingsontheleftofthebrowser
window:
•EnterthedesiredHTTPSServerPortintheHTTPSServerPortfield .The
HTTPSServer
PortistheportonwhichRASMServiceslistensforrequestsfromRoamAboutSwitch
Managerclient.
•EnterthedesiredHTTPServerPortintheSNMPfield.TheSNMPServerPortistheport
onwhichSNMPtrapsarereceived.SelectthetraptypefromwhichyouwantRoamAbout
Switch
ManagerServicestoreceiveRoamAboutSwitches,SNMPv1orSNMPv3.
Note: If a firewall is enabled on the host where you install RASM Services, RASM Services will not
be able to communicate with RASM client or with RoamAbout switches unless the firewall is
configured to allow through traffic for the SSL and SNMP ports (443 and 162 by default).
Note: By default, a username and password are not required to access RASM Services from RASM
client. You can configure user accounts for administrative, provisioning, and monitoring access.
(Refer to “RASM Access Control” on page 1-12.)
Notes: On each switch in the network plan, you must enable notifications and configure
RoamAbout Switch Manager Services as a notification target (trap receiver).
RoamAbout Switch Manager Services does not start listening for SNMP notifications from switches
until you save the network plan.