User`s guide

Installing RASM
1-10 Getting Started
Enterthepassword,ifprompted.
Tost op orrestartRASMServices,enterthefollowingcommands:
# sudo ./rm-services stop
# sudo ./rm-services restart
Eitherofthesecommandsmayrequireyoutoenterapassword.Theseexamplesassumethat
RASMServicesisinstalledinthedefaultlocation.
Connect RASM Clients to RASM Services
Toconnecttheclienttoservices:
1. SelectStart>Programs>EnterasysNetworks>RASM.TheRASMServicesConnection
wizardisdisplayed.
2. EntertheIPaddressorfully‐qualifiedhostnameofthemachineonwhichtheserviceis
installed.
IfRASMServicesisinstalledonthesamemachineastheone
youareusingtorunRASM
client,enter127.0.0.1astheIPaddress.ThisisastandardIPloopbackaddress.
3. Specifytheserviceport,ifdifferentfromtheportnumberintheServicePortlistbox.
4. ClickNexttoconnecttotheserver.
5. IftheCertificateCheckdialogisdisplayed,click
Accept.
IfyoulefttheOpenNetworkPlanoptionontheRASMServicesConnectiondialogselected,the
serveropensanew(blank)networkplan.
Note: The port number used by the monitoring service must not be used by another application on
the machine where the monitoring service is installed. If the port number is used by another
application, change the port number on the monitoring service. (Refer to Configure RASM Services
on page 1-11.)