User`s guide

Create Your RF Coverage Area
5-8 Using RF Auto-Tuning with Modelling
6. IntheRate[Mb/s]listforeachtechnology,selecttheaveragedesiredassociationratefor
typicalclientsinthiscoveragearea.
7. For802.11g,topreventtheassociationof802.11bclientstoanyradiointhiscoveragearea,
selectExclude802.11bclients.Toallow802.11bclientstoassociatetoradiosin
thecoverage
area,clearExclude802.11bclients.
8. ClickNext.TheFloorPropertiespageappears.
9. Tochangetheceilingheight,specifythenewheightintheHeightoftheCeilingbox.
10. TochangetheheightwhereAPsaremounted,specifythenewmountingheightintheAP
PlacementHeightbox.
11. ClickNext.
TheDefaultDeviceSettingspageappears.
Note: Even when association of 802.11b clients is disabled, if an 802.11b/g radio detects a
beacon from an 802.11b network, the radio enters protection mode to protect against
interference.