User`s guide

Apply a Radio Profile to Each Radio
4-6 Using RF Auto-Tuning
Apply a Radio Profile to Each Radio
WhenyoucreateaDAP,anewradio(orradios,dependinguponthe typeofDAPcreated)is
addedintoRASM.TheradiosusethedefaultradioprofileinRASMunlessyoucreateanewradio
profileandapplyittoeachradioontheAP.
Formoreinformationaboutcreating
aradioprofile,referto“CreateaRadioProfileandMapthe
ServiceProfiletoIt”onpage 4‐4.FormoreinformationaboutcreatingaDAP,referto“Create
YourDAPs”onpage 4‐4.
Toapplyaradioprofiletoaradio:
1. SelecttheConfigurationtoolbaroption.
2. IntheOrganizer
panel,clicktheplussignnexttotheRoamAboutSwitch.
3. ClicktheplussignnexttoWireless.
4. SelectRadioProfiles.
5. IntheRadioProfilestable,selecttheradioprofile.
6. ClickProperties.
7. ClicktheRadioSelectiontab.
8. SelecttheradiosintheAvailableMemberslistandclickMove.
9. ClickOK.
Youhavecompleted
thenecessarystepsforconfiguringyourRFenvironment.
What’s Next?
Afteryoucreateyourservices(Chapter 3,”ConfiguringWirelessServices”)andfollowingthe
instructionsinthissectiontocreateyourRFenvironment,deploytheconfiguration,andenable
monitoring.Optionally,youcanimproveyournetworkmonitoringoptionsbymodellingyour
flooranddefiningRFobstacles.
•Forinformationaboutmonitoringyournetwork,refer
toChapter 7,”Managingand
MonitoringYourNetwork”.
•ForinformationaboutenhancingRFAuto‐Tuningwithmodellingtobetterdefineyoursite
andimprovemonitoringoptions,refertoChapter 5,”UsingRFAuto‐Tuningwith
Modelling”.