User`s guide

Create Your DAPs
RoamAbout Switch Manager User’s Guide 4-5
AnAP’sfingerprintisthehashvalueoftheAP’spublicencryptionkey.Thefingerprintis
displayedonalabelonthebackoftheAP,andislabeledRSA key.IftheAPisalreadyinstalled
andoperating,usetheCLIcommandshowdapstatuscommandtodisplaythefingerprint.
6. Click
Next.
7. SelecttheAPmodelfromtheAPModellist.
8. Toselecttheradiotypeforasingle‐radiomodel,clicktheAPRadioTypeboxandselectthe
radiotypes:
• 11a—802.11a
• 11b—802.11bonly
• 11g—802.11b/g
9. ClickNext.
10. Configuretheradios:
a. Toenabletheradio,selectEnabled.
b. IntheChannelNumber
list,selectthechannelnumberfortheradio.
c. IntheTransmitPowerbox,specifythetransmitpowerfortheradio.
d. IftheAPhastworadios,clickNextandgobacktostep 10 .Otherwise,gotostep 11.
11. ClickFinish.
Note: The fingerprint is used for secure communication between the RoamAbout Switch and
the AP, and applies only to Distributed APs.
Notes: If RF Auto-Tuning for channel configuration is enabled, setting this value has no effect.
The channel number is controlled by RF Auto-Tuning.
Notes: If RF Auto-Tuning for power configuration is enabled, setting this value has no effect.
The power level is controlled by RF Auto-Tuning.