Specifications

Radio Interface
4-50 Advanced Configuration
• SecureAccessspecifieswhetherclientscanaccessthedefaultradiointerfacenetworkby
discoveringandautomaticallyconfiguringtheSSID,orwhetherclientsmustbealready
configuredwiththeSSID.Default:Disable
– Enabled,thisdefaultradiointerfacedeniesaccesstowirelessclientsthatdonothavethe
defaultradiointerfacenetwork
name(SSID)alreadyconfigured.Thisdefaultradio
interfacedoesnotbroadcastitsnetworkname,sothatclientswithoperatingsystemslike
WindowsXPdonotseethenameshowupinwirelessLANconfigurationdialogs.
– Disabled,thisdefaultradiointerfacebroadcastsitsnetworkname,andclientscandiscover
and
usetheSSIDtoaccessthisdefaultradiointerface’swirelessnetwork.
• IBSSRelay: InconjunctionwithIBSSRelayControlsettings(seeFilterControl onpage 4‐17),
controlswhetherclientsassociatedwiththedefaultradiointerfacecanestablishwireless
communicationswitheachotherthroughtheAP.Default:Disable
Ifyouenable
IBSSRelay,clientscanestablishwirelesscommunicationswitheachother
throughtheAP.IfyousettheIBSSRelayControltoAllVA P,thenclientsassociatedwithall
IBSSenabledradiointerfacesorVAPscanestablishwirelesscommunicationswitheachother.
IfyousettheIBSSRelayControltoPer
VA P,onlytheclientsassociatedwiththesame(IBSS
enabled)radiointerfaceorVAPcancommunicatewitheachother.
• MaximumAssociations(0‐255):Specifies thenumberofclientsallowedtoassociatewiththis
radiointerface.
• TurboMode.(802.11aONLY.)Thenormal802.11awirelessoperationmodeprovides
connectionsup
to54Mbps.TurboModeisanenhancedmode(notregulatedinIEEE802.11a)
thatprovidesahigherdatarateofupto108Mbps.EnablingTurboModeallowstheAccess
Point3000toprovideconnectionsupto108Mbps.Default: Disabled
Table 4-5 VLAN ID RADIUS Attributes
Number RADIUS Attribute Value
64 Tunnel-Type VLAN (13)
65 Tunnel-Medium-Type 802
81 Tunnel-Private-Group-ID VLANID (1 to 4095 in hexadecimal)
Note: The specific configuration of RADIUS server software is beyond the scope of this guide.
Refer to the documentation provided with the RADIUS server software.
Note: In normal mode, the access point provides a channel bandwidth of 20 MHz, and supports the
maximum number of channels permitted by local regulations (e.g., 13 channels for the United
States). In Turbo Mode, the channel bandwidth is increased to 40 MHz to support the increased data
rate. However, this reduces the number of channels supported (e.g., 5 channels for the United
States).