Specifications

Radio Interface
RoamAbout Access Point 3000 Configuration Guide 4-49
• InterfaceStatusdisables/enables useofthisdefaultradiointerface.Default:Enable.
• Descriptionisthedescriptionyouprovidetoidentifythisdefaultradiointerfac e.
• NetworkName(SSID)isthenamethatyouspecifyforthebasicservicesetprovidedbythe
defaultradiointerface.Allclientsthatwanttoconnectto
thewiredLANthroughthedefault
radiointerfacemustsettheirSSIDstothi sSSID.
• NativeVLANIDistheVLANIDforthisdefaultradiointerface.Theaccesspointassignsthis
VLANIDtoallclienttrafficusingthisradiointerfaceunlessyouassignuniqueVLANIDsto
clientsthrough
theRADIUSserverusingRFC3580(Section3.31)tunnelattributes.
UsingRFC3580(Section3.31)tunnelattributes,youmustconfigureuserVLANIDs(1‐4095)
ontheRADIUSserverforeachclientauthorizedtoaccessthenetwork.TheRADIUSserver
thenassignsaVLANIDtoaclientaftersuccessfulauthentication
usingIEEE802.1xanda
centralRADIUSserver.IfaclientdoesnothaveaconfiguredVLANID,theaccesspoint
assignstheclienttothenativeVLANIDfortheradiointerface.
WhensettingupVLANIDsforeachuserontheRADIUSserver,besuretousetheRADIUS

attributesandvaluesasindicatedinTable 4‐5.
Notes: Before enabling the radio card, you must set the country selection using the CLI. For more
information, see the RoamAbout Access Point 3000 Hardware Installation and Configuration Guide.
You must enable the default radio interface in order to configure VAPs on this radio interface.