Specifications

Administration
4-38 Advanced Configuration
• ChangeUsername/PasswordAusernameandpasswordarerequiredtoconfiguretheaccess
point.EnterasysNetworksstronglyrecommendsthatyouchange yourpasswordfromthe
defaultvaluetoensurenetworksecurity.
– Usernameisthenameoftheuser.Thedefaultnameis“admin”.Length:3‐16characters,
casesensitive.
– NewPassword
isthepasswordformanagementaccess.Length:3‐16characters,case
sensitive.
– ConfirmNewPasswordrequiresyoutore‐enterthepasswordforverification.
•ResetUsername/Password
Restorefromdefaultresetstheusernameand/orthepasswordbacktothedefaultsettings.The
defaultusernameisadminandthedefaultpasswordispassword.
Using the CLI
UsetheusernameandpasswordcommandsfromtheCLIconfigurationmode.
Enabling Disabling Com Port
Using Web Management
ComPortStatusradiobuttonsdisableorenabletheAP’scomport.Default:Enable
Using the CLI
Usethecom‐portcommandfromtheGlobalConfigurationmode.
RoamAbout 3000(config)#username John
RoamAbout 3000(config)#password ****
RoamAbout 3000(config)#confirm password ****
RoamAbout 3000(config)#exit
RoamAbout 3000#
RoamAbout 3000(config)#com-port disable
RoamAbout 3000(config)#com-port enable
RoamAbout 3000(config)#exit
RoamAbout 3000#