Specifications

Filter Control
4-18 Advanced Configuration
• ManagementVLANIDspecifiesthemanagementVLANIDfortheaccesspoint.
ThemanagementVLANisformanagingtheaccesspoint.Forexample,theaccesspoint
allowstrafficthatistaggedwiththespecifiedVLANtomanagetheaccesspointviaremote
management,SSH,SNMP,Telnet,etc.
• ManagementVLANallowsyou
toenableordisablemanagementVLANtaggingsupporton
theAccessPoint3000.Default:Disable
• EthernetUntaggedVLANIDspecifiestheVLANIDtowhichtheAPmapsuntaggedpackets
enteringthroughtheAPʹsEtherne tport.Range:1to4094
•IAPP(InterAccessPointProtocol)enablestheprotocolsignalingrequired
forwirelessclients
toroambetweendifferent802.11f‐compliantaccesspoints.SelectDisabletodisable802.11f
signaling.Default:Enable.
• IBSSRelayControl,inconjunctionwithradiointerfaceandVirtualAP(VAP)IBSSsettings,
controlswhetherclientsassociatedwithaninterfaceorVAPcanestablishwireless
communicationswithclientsassociatedwith
otherinterfacesorVAPs.Default:AllVAPmode
–InAllVA P Mode,clientsassociatedwithanyIBSSenabledradiointerfacesorVAPscan
establishwirelesscommunicationswitheachother.
–InPerVA P Mode,clientsassociatedwithaspecificIBSSenabledradiointerfaceorVAPcan
establishwirelesscommunicationswithotherclients
associatedwiththesameinterfaceor
VAP.Forexample,clientsassociatedwithVAP1canestablishwirelesscommunications
witheachotherbutnotwithclientsassociatedwithanIBSSenabledVAP2.
• WirelessAPManagementcontrolsmanagementaccesstotheAccessPoint3000fromwireless
clients.ManagementinterfacesincludetheWeb,Telnet,
orSNMP.Default:Allow
– Allowpermitsmanagementaccessfromwirelessclients.Thedefaultsetting.
– Disallowblocksmanagementaccessfromwirelessclients.
• EthernetTypeFiltercontrolschecksontheEthernettypeofallincomingandoutgoingEthernet
packetsagainsttheprotocolfilteringtable.Default:Disable
– Disable:Theaccesspointdoesnot
filterEthernetprotocoltypes.
– Enable:TheaccesspointfiltersEthernetprotocoltypesbasedontheconfigurationof
protocoltypesinthefiltertable.Ifaprotocolhasitsstatussetto“ON,”inthefiltertable,
theaccesspointfiltersthatprotocol.
– LocalManagementliststheEthernetprotocols.
– ISO
DesignatorspecifiestheISOdesignatorsforeachEthernetprotocollisted.
– Statusindicates,byradiobuttonselection,whethertheaccesspointfiltersthisEthernet
protocol.ONindicatesfilteringforthisEthernetprotocol.Offindicatesnofilteringforthis
Ethernetprotocol.