Specifications

Overview
4-2 Advanced Configuration
Table 4-1 Advanced Configuration
Menu Description Page
Identification Specifies the system name, location and contact. 4-3
TCP / IP Settings Enables DHCP, or allows you to configures the IP address, subnet
mask, gateway, and domain name servers.
4-5
RADIUS Configures the RADIUS server for wireless client authentication. 4-9
PPPoE Setup Configures the access point to support Point-to-Point Protocol over
Ethernet (PPPoE) for WAN connection to an ISP.
4-12
Authentication Configures the access point as an 802.1x authentication supplicant
with the network.
4-14
Filter Control Filters communications between wireless clients, access to the
management interface from wireless clients, and traffic matching
specific Ethernet protocol types.
4-17
QoS Allows you to select specific network traffic, prioritize it, and use
congestion-management and congestion-avoidance techniques to
provide preferential treatment.
4-22
CDP Settings Configures AP to use Cabletron Discovery Protocol (CDP) 4-26
Rogue AP Detection This feature scans the airwaves and collects information about
access points in the area.
4-29
SNMP Controls access to this access point from management stations
using SNMP, as well as the hosts that will receive trap messages.
4-31
Administration Configures user name and password for management
access;
upgrades software from local file, FTP or TFTP server;
resets
configuration settings to factory defaults; and resets the access
point.
4-37
System Log Controls logging of error messages; sets the system clock via
SNTP server or manual configuration.
4-45
802.11a Interface Configures the IEEE 802.11a interface. 4-47
Radio Settings Configures radio signal parameters, and service set parameters for
the default interface and up to seven Virtual Access Points (VAPs).
4-47
Security Configures 802.1x client authentication, with an option for MAC
address authentication, and data encryption with Wired Equivalent
Protection (WEP) or Wi-Fi Protected Access (WPA).
4-60
802.11b/g Interface Configures the IEEE 802.11b/g interface. 4-47
Radio Settings Configures radio signal parameters, and service set parameters for
the default interface and up to seven Virtual Access Points (VAPs).
4-47
Security Configures 802.1x client authentication, with an option for MAC
address authentication, and data encryption with Wired Equivalent
Protection (WEP) or Wi-Fi Protected Access (WPA).
4-60
Status Displays AP status, CDP status, station status, Neighbor AP
Detection status, and event logs.
4-77