Specifications

Command Groups
RoamAbout Access Point 3000 Configuration Guide A-155
qos mode
Thiscommandallowsyoutosetthetypeofclassificationusedbytheaccesspointbasedonthe
sourceaddress(SA),destinationaddress(DA),Ethernettype,or802.1p.
Syntax
qos mode <mode>
modeisthetypeofclassificationusedbytheaccesspoint(SA,DA,Ether‐type,or802.1p)
Default Setting
None
Command Mode
GlobalConfiguration
Command Usage
•AfteryouselectSAorDA,usetheqos mac-addrcommandtoentertheMACaddressesand
thepriority.
•AfteryouselectEther‐type,usetheqos ether-typecommandtoentertheEthernetprotocol
typeandthepriority.
•Ifyouselect802.1p,theprioritiesarebasedonthedevice(switch)attached.Nofurther
configuration
isnecessary.
Example
RoamAbout 3000#configure
Enter configuration commands, one per line. End with CTRL/Z
RoamAbout 3000(config)#qos mode SA
RoamAbout 3000(config)#