Specifications

Command Groups
RoamAbout Access Point 3000 Configuration Guide A-153
IAPP Commands
Thecommanddescribedinthissectionenablestheprotocolsignalingrequiredtoensurethe
successfulhandoverofwirelessclientsroamingbetweendifferent802.11f‐compliantaccesspoints.
Inotherwords,the802.11fprotocolcanensuresuccessfulroamingbetweenaccesspointsina
multi‐vendorenvironment.
iapp
Thiscommandenablestheprotocolsignalingrequiredtohandoverwirelessclientsroaming
betweendifferent802.11f‐compliantaccesspoints.Usethenoformtodisable802.11fsignaling.
Syntax
iapp
no iapp
Default
Enabled
Command Mode
GlobalConfiguration
Command Usage
Thecurrent802.11standarddoesnotspecifythesignalingrequiredbetweenaccesspointsin
ordertosupportclientsroamingfromoneaccesspointtoanother.Inparticular,thiscancreate
aproblemforclientsroamingbetweenaccesspointsfromdifferentvendors.Thiscommandis
usedtoenableordisable802.11fhandover
signalingbetweendifferentaccesspoints,
especiallyinamulti‐vendorenvironment.
Example
RoamAbout 3000#configure
Enter configuration commands, one per line. End with CTRL/Z
RoamAbout 3000(config)#iapp
RoamAbout 3000(config)#