Specifications

Initial Configuration Steps
3-4 Initial Configuration
7. EnableManagementVLAN.
a. Typemanagement‐vlanidandspecifyamanagementvlanid.
b. Typemanagement‐vlanenable,andresettheaccesspoint.
8. GotoChapter 4foradvancedconfiguration.
Using Web Management
TousetheWebinterfacetominimallyconfiguretheaccesspoint,followthesesteps:
1. OpenaWebbrowserandentertheaccesspoint’sIPaddressintheaddressfield:
–IfyouraccesspointusesaDHCPassignedIPaddress,makesuretheaccesspointis
connectedtoyournetworkandenterthe
DHCPassignedIPaddressinyourbrowser’s
addressfield(useyourDHCPserverorotherutilitytodet erminetheaccesspoint’sIP
address).
–IfyouraccesspointusesastaticIPaddress,connectasystemtotheaccesspoint’sEthernet
portandenterthedefaultIPaddress:http://192.168.1.1/inyourbrowser’s
addressfield.
Theaccesspoint’sLoginwindowappears.
2. EntertheusernameadminandthepasswordpasswordandclickLOGIN(formore
informationabouttheusernameandpassword,refertoChapter 4).
Note: Before enabling the VLAN feature on the access point, you must set up the network switch
port to support tagged VLAN packets from the access point. The switch port must also be
configured to accept the access point’s management VLAN ID and native VLAN IDs. Otherwise,
connectivity to the access point will be lost when you enable the VLAN feature.
RoamAbout 3000(config)#management-vlanid 10
RoamAbout 3000(config)#management-vlan enable
Reboot system now? <y/n>:y
Username: admin
Password:********