Specifications

Command Groups
RoamAbout Access Point 3000 Configuration Guide A-119
ip address
ThiscommandsetstheIPaddressfor the(10/100Base‐TX)Ethernetinterface.Usethiscommandto
settheIPaddressfortheaccesspointwhennotsettingtheIPaddressfromaDHCPserver.Use
thenoformtorestorethedefaultIPaddress.
Syntax
ip address <ip-address> <netmask> <gateway>
no ip address
•ip‐addressistheIPaddress
•netmaskisthenetworkmaskfortheassociatedIPsubnet.Thismaskidentifiesthehost
addressbitsusedforroutingtospecificsubnets
•gatewayistheIPaddressofthedefaultgateway
Default Setting
IPaddress:192.168.1.1
Netmask:255.255.255.0
Command Mode
InterfaceConfiguration(Ethernet)
Command Usage
•YoumustassignanIPaddresstothisdevicetogainmanagementaccessoverthenetwork
ortoconnecttheaccesspointtoexistingIPsubnets.Youcanmanuallyconfigureaspecific
IPaddressusingthiscommand,ordirectthedevicetoobtainanaddressfromaDHCP
serverusing
theipdhcpcommand.ValidIP addressesconsistoffournumbers,0to255,
separatedbyperiods. Anythingoutsidethisformatwillnotbeacceptedbythe
configurationprogram.
•DHCPisenabledbydefault.TomanuallyconfigureanewIPaddress,youmustfirst
disabletheDHCPclientwith
thenoipdhcpcommand.