Specifications

Command Groups
A-50
pppoe lcp echo-failure
ThiscommandsetstheLinkControlProtocol(LCP)echotimeoutforthePPPoEtunnel.
Syntax
pppoe lcp echo-failure <timeout>
timeoutisthenumberoftimeoutsallowed.Range: 1‐10
Default Setting
3
Command Mode
InterfaceConfiguration(Ethernet)
Command Usage
EchorequestsareusedtoverifytheintegrityofthelinkthroughthePPPoEtunnel.Devicesat
eitherendofthelinkcanissueanecho‐request.Devicesreceivinganecho‐requestmustreturn
anecho‐reply.
Ifalinkisbusywithlargedatatransfers,theecho‐replymaynot
beissuedinatimelymanner
causingthelinktotimeout.Ifyouexperiencethiskindofproblem,tryextendingtheecho
intervalortimeout.
Example
Related Commands
pppoelcpecho‐intervalpageA‐49
RoamAbout 3000#configure
Enter configuration commands, one per line. End with CTRL/Z
RoamAbout 3000(config)#interface ethernet
Enter Ethernet configuration commands, one per line.
RoamAbout 3000(if-ethernet)#pppoe lcp echo-failure 5
RoamAbout 3000(if-ethernet)#