Specifications

Command Groups
RoamAbout Access Point 3000 Configuration Guide A-45
show version
Thiscommanddisplaysthesoftwareversionforthesystem.
Default Setting
None
Command Mode
Exec
Example
PPPoE Commands
ThecommandsdescribedinthissectionconfigurePPPoE(Point‐to‐PointProtocoloverEthernet)
managementtunnelconnectionparametersfortheEthernetport.
RoamAbout 3000#show version
Version v2.6.7
RoamAbout 3000#
Table A-8 PPPoE Commands
Command Function Mode Page
ip pppoe Enables PPPoE on the Ethernet interface IC-E A-46
pppoe ip allocation Specifies how IP addresses for the PPPoE
tunnel are configured on the interface
IC-E A-47
pppoe ipcp dns Negotiates DNS for the PPPoE tunnel IC-E A-48
pppoe lcp echo-interval Sets LCP echo interval for the PPPoE tunnel IC-E A-49
pppoe lcp echo-failure Sets LCP echo timeout for the PPPoE tunnel IC-E A-50
pppoe local ip Sets local IP address for the PPPoE tunnel IC-E A-51
pppoe remote ip Sets remote IP address for the PPPoE tunnel IC-E A-52
pppoe username Sets the user name for the PPPoE tunnel IC-E A-53
pppoe password Sets the password for the PPPoE tunnel IC-E A-54
pppoe service-name Sets the service name for the PPPoE tunnel IC-E A-55
pppoe restart Restarts the PPPoE connection with updated
parameters
IC-E A-55
show pppoe Shows information about the PPPoE
configuration
Exec A-56