Specifications

Command Groups
RoamAbout Access Point 3000 Configuration Guide A-31
logging on
Thiscommandcontrolsloggingoferrormessages;thatis,sendingdebugorerrormessagesto
memory.Thenoformdisablestheloggingprocess.
Syntax
logging on
no logging on
Default Setting
None
Command Mode
GlobalConfiguration
Command Usage
Theloggingprocesscontrolserrormessagessavedtomemory.Youcanusethelogginglevel
commandtocontrolthetypeoferrormessagesthatarestoredinmemory.
Example
logging host
Thiscommandspecifiesasyslogserverhostthatwillreceiveloggingmessages.Usethenoform
toremovesyslogserverhost.
Syntax
logging host <1-4> <host_name | host_ip_address> <port #>
no logging host
•1‐4specifiesanindexvaluebywhichyouidentifyeachlogginghost.(Youcanspecifyupto
4logginghosts)
•host_nameisthenameofasyslogserver.Range:1‐20characters
•host_ip_addressistheIPaddressofasyslogserver
•port#specifiestheUDPport
touseforthislogginhostDefault:514
Default Setting
None
Command Mode
GlobalConfiguration
RoamAbout 3000#configure
Enter configuration commands, one per line. End with CTRL/Z
RoamAbout 3000(config)#logging on
RoamAbout 3000(config)#