Specifications

Command Groups
RoamAbout Access Point 3000 Configuration Guide A-17
ip telnet-server Enables Telnet access to this access
point.
GC A-30
Event Logging Controls logging of error messages
logging on Controls logging of error messages GC A-31
logging host Adds a syslog server host IP address that
will receive logging messages
GC A-31
logging console Initiates logging of error messages to the
console
GC A-33
logging level Defines the minimum severity level for
event logging
GC A-34
logging facility-type Sets the facility type for remote logging of
syslog messages
GC A-35
show logging Displays the state of logging Exec A-36
show events Displays all messages recorded in the
event log
Exec A-37
logging clear Clears the event log of all messages. GC A-38
System Clock Sets the system clock via an NTP/SNTP
server
sntp-server ip Specifies one or more time servers GC A-39
sntp-server enable Accepts time from the specified time
servers
GC A-40
sntp-server date-time Manually sets the system date and time GC A-41
sntp-server daylight-
saving
Sets the start and end dates for daylight
savings time
GC A-42
sntp-server timezone Sets the time zone for the access point’s
internal clock
GC A-43
show sntp Shows current SNTP configuration
settings
Exec A-43
System Status Displays system configuration and version
information
show system Displays system information Exec A-44
show version Displays version information for the
system
Exec A-45
Table A-5 System Management Commands (continued)
Command Function Mode Page