Specifications

Command Groups
RoamAbout Access Point 3000 Configuration Guide A-9
Command Groups
TheAP3000commandsfallintothefunctionalcommandgroupsshowninTable A‐3.
Theaccessmodeshowninthefollowingtablesisindicatedbythefollowingabbreviations:
• Exec(Executivemode)
• GC(GlobalConfiguration)
• IC(InterfaceConfiguration ‐general)
• IC‐E(InterfaceConfiguration‐configureEthernetinterface)
• IC‐W(InterfaceConfiguration‐configure
wirelessinterface)
• IC‐W:VA P (InterfaceConfiguration‐configure theselectedVAPforaninterface)
Table A-3 Command Groups
Command Group Description Page
General Basic commands for entering configuration mode, restarting
the system, or quitting the CLI
A-10
System Management Controls user name, password, system logs, browser
management options, clock settings, and a variety of other
system information
A-16
PPPoE Configures PPPoE management tunnel connection
parameters for the Ethernet port.
A-45
SNMP Configures community access strings and trap managers A-57
Flash/File Manages code image or access point configuration files A-76
RADIUS Configures the RADIUS client used with 802.1x
authentication
A-81
Authentication Configures IEEE 802.1x port access control and address
filtering
A-88
Filtering Filters communications between wireless clients, controls
access to the management interface from wireless clients,
and filters traffic using specific Ethernet protocol types
A-101
Interface Configures connection parameters for the Ethernet port and
wireless interface
A-106
IAPP Enables roaming between multi-vendor access points A-153
QoS Allows you to select specific network traffic, prioritize it, and
use congestion-management and congestion-avoidance
techniques to provide preferential treatment.
A-154
VLANs Configures VLAN membership A-170